Darkness Sensor Relay - Turn The 12v Light Bulb On/off

In this tutorial we will learn how to turn the 12V Light Bulb ON, when darkness is detected, using a relay module and a BH1750 Light sensor.

Hexabitz Security And Alarm System

In this project, we will learn how to make a Hexabitz Security and Alarm System.

Controlling Hexabitz Rgb Led Module Using 4x3 Keypad Via Ras

Controlling Hexabitz RGB LED Module Using 4x3 Keypad Via Raspberry Pi

Password Based Security System Using Rpi & Hexabitz

Using a HF1R0x C++ library to design a Password Based Security System

Remote Access A Raspberry Pi Hf1r0 Interface

In this project, We go through the steps on how to set up a Raspberry Pi VNC to remote access HF1R0 Interface with command lines.

Kinect-based Sentry Turret

You've seen them in video games an science fiction. You know you want to make your own.

Low-power Iot Intruder Detector With Raspberry Pi 4 + Pico

Use a Raspberry Pi Pico board along with a motion sensor to wake up the Raspberry Pi 4 and run a CV script that alerts you if a stranger is seen.

Arduino Dc Motor Speed & Direction Control Using Relays

We outlined how we can control the direction and speed of a 24v high current motor utilizing Arduino and two relays.

Lufs1

This project discusses the development of a Radar system, characterized by a security system and having specific properties, presents one of the current challenges in electronics.

Ultra Low Power Wifi Home Automation System

In a few steps we build a basic ultra low power WiFi home automation system by using Raspberry Pi, IOT Cricket module(s) and MQTT protocol

Wifi Motion Sensor With Email Notifications Battery Powered

In this project we are going to build WiFi PIR Sensor with email notification powered on a battery; without coding.

Rfid Based Attendance System

RFID based attendance system consists of RFID Reader, RFID Tag, LCD display and microcontroller unit. RFID can be interfaced to microcontroller through USART. Data is transferred from RFID cards to reader and from there to microcontroller.

Smart Blinking Id Card

A smart card with I2C NTag interface.

No Escape Sanitizer

This sanitizer puts restriction for people to enter inside the door. #shops #atm #gates #letterbox

Diy - Relay Module

In this tutorial I am going to show you how to make a simple relay module that can be used in any project.

Covid Free Contactless Cordless Bell Using Arduino And Rf

This project is an attempt to make a simple touchless cordless bell, without spending a lot from your pocket.

Analog Speedometer Using Arduino And Ir Sensor

The project describes an analog speedometer where we have used IR Sensor to calculate speed.

Reed Switch

Just about everywhere you go, you'll find a Reed Switch nearby that’s quietly doing its job. Reed switches are so pervasive that you’re probably never more than a few feet away from one at any given time.