Are you still using boring charging cables to charge your electronic devices? Then look no further! Now you can build your very own LED illuminated double helix charging stand.
Already have some of the items listed below?
No problem, once on the checkout page you’ll be able to remove any items you already have and reduce the total cost of the kit.
|Universal Qi Wireless Charging Transmitter||x1|
|USB DIY Connector Shell A Male Plug||x1|
|USB DIY Connector Shell Micro-B Plug||x1|
|USB 2.0A to micro B 2.0 1.5m Blk||x1|
|DRV8833 DC/Stepr Mtr Drivr Breakout Board||x1|
|Reduction Stepper Motor 5VDC 32-step||x1|
|M3 6.0mm Screw Zinc Plated Steel||x8|
|Metal Oxide Resistors 100 ohm 5% 1W||x3|
|Arduino Nano Every||x1|
|SPDT Slide Switch||x2|
|Purple Clear 2200mcd||x4|
|Stranded-Core Wire Spool - 25ft - 22AWG - Blue||x1|
|Stranded-Core Wire Spool - 25ft - 22AWG - White||x1|
Shopping cart powered by Mouser.com
A Qi-compatible wireless charger is embedded in the top of the 3D printed housing allowing you to charge any Qi-enabled wireless devices. A stunning glow-in-the-dark rotating double helix is mounded in the middle of the stand.
Two blacklight LED’s pulse gently to charge the double helix allowing it to glow before the LED’s fade off again. Two switches housed in the stand allow you to control both the LED’s and motors that power the spinning helix. The whole assembly is power by a single USB connection.
The Disco Helmet is available now! Light up the room and be the envy of all your friends with is amazing Arduino powered, 3D printable helmet!