Arduino Mkr1000

Unavailable

Magnifying glass icon
Arduino Mkr1000

Arduino Mkr1000


Mouser No:
485-ABX00004
Mfr. No:
ABX00004
WiFi Development Tools - 802.11 Arduino MKR1000
Out of stock
Spend another $40   to get free shipping
Arduino MKR1000 has been designed to offer a practical and cost effective solution for makers seeking to add Wi Fi connectivity to their projects with minimal previous experience in networking.





It is based on the Atmel ATSAMW25 SoC System on Chip , that is part of the SmartConnect family of Atmel Wireless devices, specifically designed for IoT projects and devices.

The ATSAMW25 is composed of three main blocks:

  • SAMD21 Cortex M0 32bit low power ARM MCU
  • WINC1500 low power 2.4GHz IEEE 802.11 b/g/n Wi Fi
  • ECC508 CryptoAuthentication
  • The ATSAMW25 includes also a single 1x1 stream PCB Antenna.





    The design includes a Li Po charging circuit that allows the Arduino/Genuino MKR1000 to run on battery power or external 5V, charging the Li Po battery while running on external power.

    Switching from one source to the other is done automatically.



    A good 32 bit computational power similar to the Zero board, the usual rich set of I/O interfaces, low power Wi Fi with a Cryptochip for secure communication, and the ease of use of the Arduino Software IDE for code development and programming.

    All these features make this board the preferred choice for the emerging IoT battery powered projects in a compact form factor.



    The USB port can be used to supply power 5V to the board.

    The Arduino MKR1000 is able to run with or without the Li Po battery connected and has limited power consumption.



    The MKR1000 Wifi module supports certificate SHA 256.

    Warning: Unlike most Arduino Genuino boards, the MKR1000 runs at 3.3V.



    The maximum voltage that the I/O pins can tolerate is 3.3V.

    Applying voltages higher than 3.3V to any I/O pin could damage the board.



    While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.

    You can find here your board warranty informations.



    Getting Started

    You can find in the Getting Started section all the information you need to configure your board, use the Arduino Software IDE , and start tinker with coding and electronics.





    Full details and examples on how to use the WiFi interface are available in the WiFi101 Library reference page.

    Arduino Mkr1000
    • Frequency - 48 MHz
    • Product - Development Boards
    • Brand - Arduino
    • Interface Type - I2C, SPI, UART
    • Antenna Connector Type - PCB
    • For Use With - ATSAMW25
    • Manufacturer - Arduino
    • Operating Supply Voltage - 5 V
    • Product Type - WiFi Development Tools
    • Protocol - WiFi - 802.11 - WiFi
    • Protocol Supported - 802.11 b/g/n
    • Standard Pack Qty - 25
    • Subcategory - Development Tools
    • Tool Is For Evaluation Of - ATSAMW25